- Sampler & vocoder
- Adding samples via Wooveconnect
- Levels, VU Metering & monitoring
- Sampling sounds from the audio input
- Skip-back sampling (resampling)
- Vocoder
- Working with slices
- Auto-slicing
- Real-time pitch and time warping
- Amen chop tutorial
- Multi-sampled instruments and percussion
- Using the two sample banks
- Using samples and kits in your songs
- Using single-cycle AKWF samples
- Using Amiga Tracker samples
- Using Teenage Engineering OP-1 / OP-Z sample kits
- Kit and/or master sample initialization
- Backing up sample kits
- Auto-space reclaimer
- Limitations
- Sampler & vocoder
- Limitations
Limitations
The following limitations currently apply to the Woovebox sampler;
- Two banks with 62.4 seconds (for a total of sampling time of 124.8 seconds) each are available. However only one bank may be used in a song. Samples from the other bank will not be available for use in your song.
- Recordings may be any length, however individual sample slices may not be longer than 11.8 seconds.
- Samples recorded through the line-in input are sampled at 44.1KHz with 8-bit with mu-law compression (~12-bit effective dynamic range) as found in the vintage Emu Emulator II sampler. Samples with low harmonic content (e.g. sine waves, synthesized kicks) may exhibit quantization noise due the the dynamic range compression. If this is an issue, consider importing your sample via Wooveconnect. Wooveconnect-imported samples are analysed for their harmonic content, upon which the least lossy encoding scheme is chosen (44.1KHz 8-bit mulaw or 22.05KHz 16-bit).
- Resampled internal sounds (via skip-back recording) are recorded at 22.05KHz 16-bit uncompressed resolution.
- Mixed storage type (for example 44.1KHz 8-bit mu-law mixed with 22.05KHZ 16-bit) slices are allowed, however changing their start and end positions in the master sample will yield invalid audio if these start and end points start including audio encoded in a different format that that of the rest of the slice.
You may also be interested in...
- Wooveconnect 2 (under Support, guides & tutorials)
- Launch Wooveconnect 2
Manage songs, samples, audio stems, firmware updates and more through Wooveconnect.
- File formats (under Wooveconnect 2)
Digital audio is exported and imported as 44.1KHz .WAV files.
- Turning off Wooveconnect CC messages (under MIDI, Sync and connecting other gear)
Device mirroring is off by default, if the device was not booted up with BLE enabled.
- Using Wooveconnect once connected (under Wooveconnect 2)
Uploads are initiated by dragging and dropping .WAV, .AIFF or .SYX files into Wooveconnect.
- Sampler & vocoder
- Adding samples via Wooveconnect
- Levels, VU Metering & monitoring
- Sampling sounds from the audio input
- Skip-back sampling (resampling)
- Vocoder
- Working with slices
- Auto-slicing
- Real-time pitch and time warping
- Amen chop tutorial
- Multi-sampled instruments and percussion
- Using the two sample banks
- Using samples and kits in your songs
- Using single-cycle AKWF samples
- Using Amiga Tracker samples
- Using Teenage Engineering OP-1 / OP-Z sample kits
- Kit and/or master sample initialization
- Backing up sample kits
- Auto-space reclaimer
- Limitations