- Song-wide settings
- MStr (mastering)
MStr (mastering)
The mastering page controls mastering-specific settings for the master compressor, mid/side processing, and noise/vintage emulation character.
Please also see the mastering documentation.
1. WidE StEo Wdth Stereo Width
Specifies the stereo width enhancement that should be applied to the final audio. 100% is normal (not enhanced) width.
2. Mono bass mono-fy
Specifies the frequency below which audio should be progressively "monofied" (pulled to the center of the stereo field).
5. noi.F Noise Floor
Sets a base noise floor (0-127) below which artificially introduced noise is always audible. A slight base noise floor can be instrumental in emulating vinyl or tape hiss.
6. noi.c Noise Character
Sets the character of the artificially introduced noise floor. Lower values exhibit a subtle high frequency periodicity, found in some vintage analog equipment such as record players. Higher values tend to whiter noise.
7. Vn.Cr Vinyl Crackle
The amount of emulated vinyl crackle to introduce into the final signal. Negative values for this parameter will only add vinyl crackle while the song is playing.
9. MC.th Master Compressor threshold
Sets the threshold (0-100) above which the master compressor/limiter should kick in. 0 means always on (compression of any signal), 100 means always off (signal never high enough to start compression).
10. MC.rt Master Compressor ratio
Sets the compression ratio for the master compressor. A value of 1 effectively turns off the compressor. A value higher than 12 (for a 1:12 compression ratio) is generally considered to act as a limiter, rather than a compressor.
11. MC.at Master Compressor attack
Specifies how fast the master compressor/limiter should respond to the threshold being exceeded, enabling compression.
12. MC.rL Master Compressor release
Specifies how fast the master compressor/limiter should respond to the signal dipping below the threshold, disabling compression.
13. MC.Lo Master Compressor Low Band Amplification
Specifies the amplification of the low band (<170Hz for OTT, progressively below 1750Hz for up, down and up/down) of the compressed signal.
14. MC.Md Master Compressor Mid Band Amplification
Specifies the amplification of the mid band (170Hz-2500Hz for OTT, and a bell curve around 1750Hz for up, down and up/down) of the compressed signal.
15. MC.Hi Master Compressor High Band Amplification
Specifies the amplification of the high band (>2500Hz for OTT, progressively above 1750Hz for up, down and up/down) of the compressed signal.
You may also be interested in...
- Rezzonator: "Sequencer Page Tutorial" (under Reviews, videos, tutorials)
- AI DSP resource allocation optimizer (under Understanding DSP load)
Once trained on your song or patterns, the optimizer can reduce DSP loads by ~10% in typical cases.
- Chord locking (under Fragments; arranging and building your song)
'Post'; the track will lock to any chord that immediately starts playing at the start of this fragment.
- Variations through replicable random takes (under Fragments; arranging and building your song)
Each number represents a different sequence of random (but fixed) events.
- Randomization (under Full documentation, guide and tutorial)
This "fixed" sequence will be different/random for every random number you choose for 7/hh/'SEEd'.