15. Hal.N North pole Hall sensor mapping
Specifies which parameter the detected south pole magnetic field strength should map to;
- 'Off'; the sensor will not respond to a magnet for this polarity
- 'Fltr'; magnet proximity will cause filter to close for this polarity
- 'FLFO'; magnet proximity will cause filter LFO to modulate filter cut-off frequency for this polarity
- 'PLF.1'; magnet proximity will allow pitch LFO 1 to modulate for this polarity
- 'PLF.2'; magnet proximity will allow pitch LFO 2 to modulate for this polarity
- 'PL.1.2'; magnet proximity will allow pitch LFO 1 and 2 to modulate for this polarity
- 'Vol'; magnet proximity will cause volume to decrease
- 'ALF.1'; magnet proximity will allow amplitude LFO 1 to modulate for this polarity
- 'ALF.2'; magnet proximity will allow amplitude LFO 2 to modulate for this polarity
- 'AL.1.2'; magnet proximity will allow amplitude LFO 1 and 2 to modulate for this polarity
You may also be interested in...
- 16. L2.Ho LFO 2 Hold (under Pitch page)
- 15. L2.rt LFO 2 rate (under Pitch page)
Specifies the rate (in steps) in which the LFO should complete a cycle.
- 12. Au.Ho Auto-Pan LFO Hold (under Panning page)
Specifies the hold time for the auto-pan LFO in milliseconds.
- 7. P.L.tr Pitch LFO retrigger (under Osc1 and Osc2 oscillator page)
'rand' will start the LFO at a random phase (location in the chosen waveform).
- 6. A.L.tr Amplitude LFO trigger (under Osc1 and Osc2 oscillator page)
'rand' will start the LFO at a random phase (location in the chosen waveform).