14. rv.dM Reverb Damping
Specifies reverb damping, impacting how clear the "tail" of the reverb should be. This simulates objects and materials absorbing certain frequencies. Frequencies below above the specified frequency will be cut. A frequency of 3520 yields a "natural" reverb where high frequencies gradually decay, while "PaSS" performs no damping at all. The latter combined with a high feedback value can yield some extremely long reverbs.
You may also be interested in...
- Without ducking (under Example)
- 13. St.Wv Start Position LFO waveform (under Panning & EQ page)
Waveform for Start Position LFO: Noise, Sine, Triangle, Saw, Square.
- 13. L.C.Wv Waveform for cutoff frequency LFO (under Filter page)
- 5. L1.Wv LFO 1 Waveform (under Amplitude page)
'SinE'; sine wave (starts at 0 / 90 degree phase, ramping up).
- 14. L.C.de depth for cutoff frequency LFO (under Filter page)
Specifies the strength by which the LFO should affect the filter.